The factory YJ axle setup was a reverse-cut Dana 30 up front and a Dana 35 in the rear. Vehicles with a 6-cylinder engine had a 3.07 front, 3.08 rear ring and pinion gear ratio. Vehicles with a 4-cylinder engine had a 4.10 front, 4.11 rear ratio.

[phpbay keywords=”wrangler yj dana (30,35) -(cable,cover,locker,master,pin,posi,ring,seal,shaft,spider,yoke)” num=”100″ siteid=”1″ category=”33726″ customid=”Full Doors” listingtype=”BIN” sortorder=”EndTimeSoonest” itemsperpage=”20″ paging=”true” templatename=”arriviste”]

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.